This is a follow up post to my previous POST where I showed a cute card featuring the “Patchwork Pieces” Dies and the “Inked Botanicals” DSP. When I created the previous card, I had die cut three different DSP patterns from the “Inked Botanicals” prints. Here are the other two cards I created with the remaining die cut pieces.
For the “Thank You” card, I chose to place the die cut pieces on a Very Vanilla layer allowing a slight space between the die cut pieces. That layer was placed on a larger Crushed Curry layer. Then, l used the “stitched flag” and “circle” shapes from the “Stylish Shapes” Dies to build my focal point. The greeting was layered on to the “star” punch from the “Inked & Tiled” Punch Pack. Then I elevated the greeting with “Dimensionals” on to the die cut “flag” shape. To complete this card, I tied a double strand of “Vanilla Baker’s Twine” and attached with a “Glue Dot”.
For the “Thinking of You” card, I embossed a Very Vanilla panel of card stock with the “Metal Plate 3D” Embossing Folder. I chose to mount this piece so the debossed side was showing. The “Patchwork Pieces” Dies were attached to Very Vanilla rectangles and then layered on to a Calypso Coral layer. Basically, the larger die cut rectangle was separated into four smaller rectangles. The greeting was die cut with the “stitched circle” from the “Stylish Shapes” Dies, layered on to another circle shape. This was then layered on to a “Decorative Circle” Punch in Calypso Coral. A piece of “Gold & Vanilla Satin Edge Ribbon” was folded and attached behind the greeting layer. Both cards were fairly simple to create!
